diff --git a/arch/arm/cpu/armv7/omap3/mem.c b/arch/arm/cpu/armv7/omap3/mem.c
deleted file mode 100644
index 1832aff..0000000
--- a/arch/arm/cpu/armv7/omap3/mem.c
+++ /dev/null
@@ -1,139 +0,0 @@
-/*
- * (C) Copyright 2008
- * Texas Instruments, <www.ti.com>
- *
- * Author :
- *     Manikandan Pillai <mani.pillai@ti.com>
- *
- * Initial Code from:
- *     Richard Woodruff <r-woodruff2@ti.com>
- *     Syed Mohammed Khasim <khasim@ti.com>
- *
- * SPDX-License-Identifier:	GPL-2.0+
- */
-
-#include <common.h>
-#include <asm/io.h>
-#include <asm/arch/mem.h>
-#include <asm/arch/sys_proto.h>
-#include <command.h>
-
-struct gpmc *gpmc_cfg;
-
-#if defined(CONFIG_CMD_NAND)
-static const u32 gpmc_m_nand[GPMC_MAX_REG] = {
-	M_NAND_GPMC_CONFIG1,
-	M_NAND_GPMC_CONFIG2,
-	M_NAND_GPMC_CONFIG3,
-	M_NAND_GPMC_CONFIG4,
-	M_NAND_GPMC_CONFIG5,
-	M_NAND_GPMC_CONFIG6, 0
-};
-#endif /* CONFIG_CMD_NAND */
-
-#if defined(CONFIG_CMD_ONENAND)
-static const u32 gpmc_onenand[GPMC_MAX_REG] = {
-	ONENAND_GPMC_CONFIG1,
-	ONENAND_GPMC_CONFIG2,
-	ONENAND_GPMC_CONFIG3,
-	ONENAND_GPMC_CONFIG4,
-	ONENAND_GPMC_CONFIG5,
-	ONENAND_GPMC_CONFIG6, 0
-};
-#endif /* CONFIG_CMD_ONENAND */
-
-/********************************************************
- *  mem_ok() - test used to see if timings are correct
- *             for a part. Helps in guessing which part
- *             we are currently using.
- *******************************************************/
-u32 mem_ok(u32 cs)
-{
-	u32 val1, val2, addr;
-	u32 pattern = 0x12345678;
-
-	addr = OMAP34XX_SDRC_CS0 + get_sdr_cs_offset(cs);
-
-	writel(0x0, addr + 0x400);	/* clear pos A */
-	writel(pattern, addr);		/* pattern to pos B */
-	writel(0x0, addr + 4);		/* remove pattern off the bus */
-	val1 = readl(addr + 0x400);	/* get pos A value */
-	val2 = readl(addr);		/* get val2 */
-	writel(0x0, addr + 0x400);	/* clear pos A */
-
-	if ((val1 != 0) || (val2 != pattern))	/* see if pos A val changed */
-		return 0;
-	else
-		return 1;
-}
-
-void enable_gpmc_cs_config(const u32 *gpmc_config, struct gpmc_cs *cs, u32 base,
-			u32 size)
-{
-	writel(0, &cs->config7);
-	sdelay(1000);
-	/* Delay for settling */
-	writel(gpmc_config[0], &cs->config1);
-	writel(gpmc_config[1], &cs->config2);
-	writel(gpmc_config[2], &cs->config3);
-	writel(gpmc_config[3], &cs->config4);
-	writel(gpmc_config[4], &cs->config5);
-	writel(gpmc_config[5], &cs->config6);
-
-	/*
-	 * Enable the config.  size is the CS size and goes in
-	 * bits 11:8.  We set bit 6 to enable this CS and the base
-	 * address goes into bits 5:0.
-	 */
-	 writel((size << 8) | (GPMC_CS_ENABLE << 6) |
-				 ((base >> 24) & GPMC_BASEADDR_MASK),
-				 &cs->config7);
-	sdelay(2000);
-}
-
-/*****************************************************
- * gpmc_init(): init gpmc bus
- * Init GPMC for x16, MuxMode (SDRAM in x32).
- * This code can only be executed from SRAM or SDRAM.
- *****************************************************/
-void gpmc_init(void)
-{
-	/* putting a blanket check on GPMC based on ZeBu for now */
-	gpmc_cfg = (struct gpmc *)GPMC_BASE;
-#if defined(CONFIG_CMD_NAND) || defined(CONFIG_CMD_ONENAND)
-	const u32 *gpmc_config = NULL;
-	u32 base = 0;
-	u32 size = 0;
-#endif
-	u32 config = 0;
-
-	/* global settings */
-	writel(0, &gpmc_cfg->irqenable); /* isr's sources masked */
-	writel(0, &gpmc_cfg->timeout_control);/* timeout disable */
-
-	config = readl(&gpmc_cfg->config);
-	config &= (~0xf00);
-	writel(config, &gpmc_cfg->config);
-
-	/*
-	 * Disable the GPMC0 config set by ROM code
-	 * It conflicts with our MPDB (both at 0x08000000)
-	 */
-	writel(0, &gpmc_cfg->cs[0].config7);
-	sdelay(1000);
-
-#if defined(CONFIG_CMD_NAND)	/* CS 0 */
-	gpmc_config = gpmc_m_nand;
-
-	base = PISMO1_NAND_BASE;
-	size = PISMO1_NAND_SIZE;
-	enable_gpmc_cs_config(gpmc_config, &gpmc_cfg->cs[0], base, size);
-#endif
-
-#if defined(CONFIG_CMD_ONENAND)
-	gpmc_config = gpmc_onenand;
-	base = PISMO1_ONEN_BASE;
-	size = PISMO1_ONEN_SIZE;
-	enable_gpmc_cs_config(gpmc_config, &gpmc_cfg->cs[0], base, size);
-#endif
-}